• Robert Dansaertlaan, 250 - 1702 Groot-Bijgaarden - Belgium

Insulating panel A3

SKU: INSULP-A3 Category:

Product description

Protection during insertion and removal by working rods
The insulating protective plate has a holder for the working rod and may only be inserted and removed with this.
This design is suitable for switch cells with a high construction.

Please note:
For panels over 1m², operation by two people is required.
In this case, two supports for working rods must be planned.
If possible, you should use the swivel-push system developed.

With this system, two guide rails
and two bearing bolts are mounted in the switchgear cell.
The swivel push plate can then be hooked into the bearing bolts with one or two working rods
and easily swiveled in.
Guide rails are required in any case with this design.

     

When filling out the planning sheet, please provide the following information:

B = width of the protective plate
LS = length of the protective part
I = pivot point of the hook or center point of the bayonet bolt measured from the front edge of the protective plate
LG = length of the working rod
(Table of standard equipment)
Number of recesses (if necessary)
Position of the recesses (can be marked on planning sheet page 11)
Length of the guide rails
Order number of the desired accessories
Design, number of pieces, accessories, plate thickness
Color (signal red or crystal clear)

Close ✕

Group Filter

Filter category

Class

Max. Use Voltage

Endfitting

Compare Products